Cutter Controller V1.0.20 has been Released

[The Wizard]

Cutter Controller V1.0.20 can be purchased from http://www.ideas-r-us-software.uk/Shop/ShopProducts.aspx

The Demo release of Cutter Controller V1.0.20 can be downloaded from http://ideas-r-us-software.uk/Downloads.aspx


See http://www.ideas-r-us-software.uk/CutterController.aspx


New Features
- Enabled support for Provo Craft Cricut machines
- Added a grid overlay to the virtual mat/roll, that can be turned on/off via the 'View' menu, and the grid settings to the 'Settings' menu. The grid settings (grid line style, grid colour, line width, grid spacing, and opacity) are saved/loaded.
- The units (Inches/Millimetres) state, and the wire frame state (Colour/Mono) are saved/loaded.
- The 'Cut By' panel's position is now saved/loaded.
 
Improvements Made
- Increased the canvas/drawing area, by moving the 'Drawing Dimensions', 'Speed and Force', 'Calibrate X/Y Scaling', 'Contour Cut', and 'Contour Cut Calibration' group panels.
- The 'Drawing Dimensions', 'Speed and Force', 'Contour Cut', and 'Contour Cut Calibration' group panels are now movable.
- The 'Drawing Dimensions', and 'Speed and Force' panel's visibility (via the 'View' menu) and position can be saved.
- The 'Contour Cut', and 'Contour Cut Calibration' group panel can be moved.

Issues Fixed
- Bezier curves with the control points outside the bounding box resulted in the control points being the bounding box. Fixed.
- The mat size 24" x 12" on Cricut Expression is not been detected. Ignore the error. It may be the Circut Expression used to test is at fault. Fixed.
- The scroll bars were not moving the drawing the correct amount, and were jerky. Fixed.