Recent Posts

Pages: [1] 2 3 ... 10

Online Converters for FCM, GSD and Studio to SVG / Re: No File after converting

« Last post by The Wizard on 29 December 2021, 12:34:00 »

Hello

The file has converted okay, but the filename contains special characters "HimpsPimps+-+Rakete.svg" causes problems when a browser tries to display it. Try to remove the '+' characters from the filename before uploading the file for conversion.

http://www.ideas-r-us-software.uk/FileConversions/StudioToSVGConversions/HimpsPimps+-+Rakete.svg

Ian

Online Converters for FCM, GSD and Studio to SVG / No File after converting

« Last post by AlexC on 29 December 2021, 12:08:27 »

Hi,
I tried to convert file, but after converting the file is shown for downloading, but there is no file.
I tried chrome and edge, both same problem.

Brother FCM Thumbnail Viewer V1.x / Re: Request for Update to FCM Viewer

« Last post by The Wizard on 23 October 2021, 12:32:59 »

Hello

The thumbnails that you see are taken from the FCM files, and making them any bigger would only pixelate them.

There is a thumbnail creator that will create bigger thumbnails from the FCM files (and other files as well), but it doesn’t create a thumbnail sheet, just the thumbnails. http://www.ideas-r-us-software.uk/Downloads.aspx#VectorFileThumbnailCreator

Ian

Brother FCM Thumbnail Viewer V1.x / Request for Update to FCM Viewer

« Last post by chambers120 on 22 October 2021, 16:23:28 »

I'd like to request the addition of adding the ability to change size of the thumbs in the printout so that the images were be easier to view.
Thanks for you consideration.
chambers120

Machines / Re: Does anybody know about engraving laser?

« Last post by The Wizard on 30 June 2021, 12:45:54 »

Hello

You may not get any replies, since the forum deals mainly with electronic cutting (blade) and plotting machines.

Ian

Machines / Does anybody know about engraving laser?

« Last post by hope on 30 June 2021, 06:46:24 »

Could anyone recommend some engraving lasers for me? I prefer one under $2000 and not too big. Better the CO2 engraving laser. Did I found one engraving laser:https://omtechlaser.com/collections/desktop-co2-laser-engravers/products/40w-co2-laser-engraver-cutter-usb-032r-us and anybody used it before?